Improve __ieee754_exp() performance by greater than 5x on sparc/x86.

These changes will be active for all platforms that don't provide
their own exp() routines. They will also be active for ieee754
versions of ccos, ccosh, cosh, csin, csinh, sinh, exp10, gamma, and
erf.

Typical performance gains is typically around 5x when measured on
Sparc s7 for common values between exp(1) and exp(40).

Using the glibc perf tests on sparc,
      sparc (nsec)    x86 (nsec)
      old     new     old     new
max   17629   395    5173     144
min     399    54      15      13
mean   5317   200    1349      23

The extreme max times for the old (ieee754) exp are due to the
multiprecision computation in the old algorithm when the true value is
very near 0.5 ulp away from an value representable in double
precision. The new algorithm does not take special measures for those
cases. The current glibc exp perf tests overrepresent those values.
Informal testing suggests approximately one in 200 cases might
invoke the high cost computation. The performance advantage of the new
algorithm for other values is still large but not as large as indicated
by the chart above.

Glibc correctness tests for exp() and expf() were run. Within the
test suite 3 input values were found to cause 1 bit differences (ulp)
when "FE_TONEAREST" rounding mode is set. No differences in exp() were
seen for the tested values for the other rounding modes.
Typical example:
exp(-0x1.760cd2p+0)  (-1.46113312244415283203125)
 new code:    2.31973271630014299393707e-01   0x1.db14cd799387ap-3
 old code:    2.31973271630014271638132e-01   0x1.db14cd7993879p-3
    exp    =  2.31973271630014285508337 (high precision)
Old delta: off by 0.49 ulp
New delta: off by 0.51 ulp

In addition, because ieee754_exp() is used by other routines, cexp()
showed test results with very small imaginary input values where the
imaginary portion of the result was off by 3 ulp when in upward
rounding mode, but not in the other rounding modes.  For x86, tgamma
showed a few values where the ulp increased to 6 (max ulp for tgamma
is 5). Sparc tgamma did not show these failures.  I presume the tgamma
differences are due to compiler optimization differences within the
gamma function.The gamma function is known to be difficult to compute
accurately.

	* sysdeps/ieee754/dbl-64/e_exp.c: Include <math-svid-compat.h> and
	<errno.h>.  Include "eexp.tbl".
	(half): New constant.
	(one): Likewise.
	(__ieee754_exp): Rewrite.
	(__slowexp): Remove prototype.
	* sysdeps/ieee754/dbl-64/eexp.tbl: New file.
	* sysdeps/ieee754/dbl-64/slowexp.c: Remove file.
	* sysdeps/i386/fpu/slowexp.c: Likewise.
	* sysdeps/ia64/fpu/slowexp.c: Likewise.
	* sysdeps/m68k/m680x0/fpu/slowexp.c: Likewise.
	* sysdeps/x86_64/fpu/multiarch/slowexp-avx.c: Likewise.
	* sysdeps/x86_64/fpu/multiarch/slowexp-fma.c: Likewise.
	* sysdeps/x86_64/fpu/multiarch/slowexp-fma4.c: Likewise.
	* sysdeps/generic/math_private.h (__slowexp): Remove prototype.
	* sysdeps/ieee754/dbl-64/e_pow.c: Remove mention of slowexp.c in
	comment.
	* sysdeps/powerpc/power4/fpu/Makefile [$(subdir) = math]
	(CPPFLAGS-slowexp.c): Remove variable.
	* sysdeps/x86_64/fpu/multiarch/Makefile (libm-sysdep_routines):
	Remove slowexp-fma, slowexp-fma4 and slowexp-avx.
	(CFLAGS-slowexp-fma.c): Remove variable.
	(CFLAGS-slowexp-fma4.c): Likewise.
	(CFLAGS-slowexp-avx.c): Likewise.
	* sysdeps/x86_64/fpu/multiarch/e_exp-avx.c (__slowexp): Do not
	define as macro.
	* sysdeps/x86_64/fpu/multiarch/e_exp-fma.c (__slowexp): Likewise.
	* sysdeps/x86_64/fpu/multiarch/e_exp-fma4.c (__slowexp): Likewise.
	* math/Makefile (type-double-routines): Remove slowexp.
	* manual/probes.texi (slowexp_p6): Remove.
	(slowexp_p32): Likewise.

1 files changed, 0 insertions, 14 deletions

diff --git a/manual/probes.texi b/manual/probes.texi
index 8ab67562d7..f8ae64be33 100644
--- a/manual/probes.texi
+++ b/manual/probes.texi
@@ -258,20 +258,6 @@ Unless explicitly mentioned otherwise, a precision of 1 implies 24 bits of
 precision in the mantissa of the multiple precision number.  Hence, a precision
 level of 32 implies 768 bits of precision in the mantissa.
 
-@deftp Probe slowexp_p6 (double @var{$arg1}, double @var{$arg2})
-This probe is triggered when the @code{exp} function is called with an
-input that results in multiple precision computation with precision
-6.  Argument @var{$arg1} is the input value and @var{$arg2} is the
-computed output.
-@end deftp
-
-@deftp Probe slowexp_p32 (double @var{$arg1}, double @var{$arg2})
-This probe is triggered when the @code{exp} function is called with an
-input that results in multiple precision computation with precision
-32.  Argument @var{$arg1} is the input value and @var{$arg2} is the
-computed output.
-@end deftp
-
 @deftp Probe slowpow_p10 (double @var{$arg1}, double @var{$arg2}, double @var{$arg3}, double @var{$arg4})
 This probe is triggered when the @code{pow} function is called with
 inputs that result in multiple precision computation with precision